Why Can't I Upload The Firmware And Configuration File Using; Ftp Over Wan; Log And Alert; When Does The Amg1302-T10B/Amg1202-T10B Generate The Firewall Log - ZyXEL Communications AMG1202-T10B Support Notes

(4)A filter set which blocks WWW/Telnet from WAN is applied to WAN
node.

4. Why can't I upload the firmware and configuration file using

FTP over WAN?

(1) When the firewall is turned on, all connections from WAN to LAN are
blocked by the default ACL rule. To enable FTP from WAN, you must turn
the firewall off or create a firewall rule to allow FTP connection from WAN.
The WAN-to-LAN ACL summary will look like as shown below.
Source IP= FTP host
Destination IP= AMG1302-T10B/AMG1202-T10B's WAN IP
Service= FTP TCP/21, TCP/20
Action=Forward
(2) You have disabled FTP service in Web Configurator, Advanced setup,
Maintenance -> RemoteMGNT.
(3) FTP service is enabled but your host IP is not the secured host entered
in Web Configurator, Advanced setup, Maintenance -> RemoteMGNT.
(4) A filter set which blocks FTP from WAN is applied to WAN node.

Log and Alert

1. When does the AMG1302-T10B/AMG1202-T10B generate the
firewall log?
The AMG1302-T10B/AMG1202-T10B generates the firewall log immediately
when the packet matches a firewall rule. The log for Default Firewall Policy
(LAN to WAN, WAN to LAN, WAN to WAN) is generated automatically with
factory default setting, but you can change it in Web Configurator.

2. What does the log show to us?

The log supports up to 128 entries. There are 5 columns for each entry. Please
see the example shown below:
All contents copyright © 2013 ZyXEL Communications Corporation.
AMG1202-T10B/AMG1302-T10B
Support Notes
24