ZyXEL Communications NXC2500 User Manual page 409

Table 212 CAPWAP Server Logs
LOG MESSAGE
VLAN setting is
conflict.MAC:%02x:%02x:%02x:%02
x:%02x:%02x,Model:%s,
Mgnt. VID(AC):%d, %s, Mgnt.
VID(AP):%d,%s
AP doesn't support %s feature.
MAC:%02x:%02x:%02x:%02x:%02x:%0
2x,AP:%s
Table 213 CAPWAP Client Logs
LOG MESSAGE
AP Start. Discovery Type:%s
AP Reset. Discovery Type:%s
Connect to WLAN Controller. IP:%s
Disconnect from WLAN Controller.
IP:%s
Updated Configuration by a WLAN
Controller Success. Partial
Update
Updated Configuration by a WLAN
Controller Fail.
ReBoot by a WLAN Controller.
IP:%s
Firmware Upgraded by WLAN
Controller. IP:%s
Apply Configuration by a WLAN
Controller Success.%s
WLAN Controller IP Changed. New
Discovery Type:%s, WLAN
Controller IP: %s
Appendix A Log Descriptions
DESCRIPTION
The VLAN ID of the AC is not the same as the VLAN ID of the AP.
1st %02x~6th%02x: Managed AP MAC Address.
7th %s: Managed AP Description.
8th %d: VID , 9th %s: tag or untag
10th %d: VID , 11th %s: tag or untag
An AP doesn't support a feature.
1st %s: feature name
2st %02x~7th%02x: Managed AP MAC Address.
8th %s: Managed AP Description.
DESCRIPTION
Start the CAPWAP Client service.
1st %s: Discovery type {Static | DHCP | DNS | Broadcast}
Reset the CAPWAP Client service.
1st %s: Discovery type {Static | DHCP | DNS | Broadcast}
CAPWAP Client connected to the WLAN Controller.
1st %s: WLAN Controller IP Address.
CAPWAP Client disconnected from to the WLAN Controller.
1st %s: WLAN Controller IP Address.
Configuration upgraded success by WLAN Controller.
Configuration upgraded fail by WLAN Controller.
Reboot the WTP by WLAN Controller.
1st %s: WLAN Controller IP Address.
Firmware upgraded by WLAN Controller.
1st %s: WLAN Controller IP Address.
Configuration apply success by WLAN Controller.
1st %s: Complete Update
Changed WTP's AC IP.
1st %s: Discovery type {Static | DHCP | DNS | Broadcast}
2nd %s: WLAN Controller IP Address
NXC Series User's Guide
409