Honda 2004 Odyssey Service Manual page 139

Cruise Control
Cruise Control Actuator/Cable
Replacement
1. Loosen the locknut (A), then disconnect the
actuator cable (B) from the throttle linkage.
B
2. Disconnect the 4P connector (A) from the cruise
control actuator.
A
B
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
3. Remove the three mounting bolts (B), and remove
the cruise control actuator assembly (C).
4. Install actuator/cable in the reverse order of
removal, and adjust the free play at the throttle
linkage (see page 4-52) after connecting the
actuator cable.
4-52 4-52
Cruise Control Actuator Cable
Adjustment
1. Check that the actuator cable (A) moves smoothly
A
2. Start the engine, and turn the main switch ON. Hold
B
3. Measure the amount of movement of the output
6 x 1.0 mm
12 N·m
(1.2 kgf·m,
8.7 lbf·ft)
4. If the free play is not within specification, move the
C
with no binding or sticking.
D
C
B
the engine at 3,000 rpm with no load in Park or
Neutral until the radiator fan comes on, then let it
idle.
linkage (B) until the engine speed starts to increase.
At first, the output linkage should be located at the
fully closed position (C). The free play (D) should be
3.75 0.5 mm (0.15 0.02 in.).
cable to the point where the engine speed starts to
increase, and tighten the locknut (A) and adjusting
nut (B).
A
A
B