Honda 2004 Odyssey Service Manual page 242

9. Remove the connecting rod caps after setting the
crank pin at bottom dead center (BDC) for each
cylinder. Remove the piston assembly by pushing
on the connecting rod. Take care not to damage the
crank pin or cylinder with the connecting rod.
CORRECT
INCORRECT
10. Remove the bearing from the cap. Keep all caps/
bearings in order.
11. Remove the upper bearing halves from the
connecting rods, and set them aside with their
respective caps.
12. After removing a piston/connecting rod assembly,
reinstall the cap on the rod.
13. To avoid mixup during reassembly, mark each
piston/connecting rod assembly with its cylinder
number.
14. Unscrew the bearing cap bolts and bearing cap
side bolts in sequence 1/3 turn at a time; repeat the
sequence until all bolts are loosened.
(cont'd)
7-13