Installing A Summit X650 Ac Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing a Summit X650 AC Power Supply

CAUTION
Make sure that the AC PSU circuit is not overloaded. Use proper over-current protection, such as a circuit-breaker,
to prevent over-current conditions.
To install a Summit X650 AC PSU:
1 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
grounding point.
2 If necessary, remove a blank panel from the back of the Summit X650 series switch
Figure 133: Removing a Blank Panel
3 Verify that the PSU is right side up, with the latching tab at the right of the unit (see
4 Carefully slide the PSU all the way into the power supply bay (see
the latch snaps into place.
CAUTION
Do not slam the PSU into the switch.
Summit Family Switches Hardware Installation Guide
SH_088
Figure 134). Push the PSU in until
(Figure 133).
Figure 134).
157