Installing The Replacement Power Supply; Connecting The Ground Wire - Extreme Networks Summit X150-24t Hardware Installation Manual

Confidential and proprietary information of Extreme Networks. © 2011 Extreme Networks, Inc.

Installing the Replacement Power Supply

To install a replacement Summit 300 W DC power supply:
1 Verify that the power supply is right side up (see
2 Carefully slide the power supply all the way into the power supply bay (see
power supply in until the latch snaps into place.
CAUTION
Do not slam the power supply into the switch.
Figure 241: Installing a Summit 300 W DC Power Supply

Connecting the Ground Wire

To connect the ground wire to the Summit 300 W DC power supply:
1 Verify that the DC circuit is de-energized.
2 Identify the grounding point on the front panel of the power supply (see
3 Insert an M3.5 screw (provided) through the ring terminal on the ground wire and into the
grounding point on the power supply.
4 Tighten the screw to 12.6 inch-pounds.
5 Connect the other end of the wire to a known reliable earth ground point at your site.
Figure 242: Connecting the Ground Wire
1
2
1 = Grounding point
2 = Ground wire
Summit Family Switches Hardware Installation Guide
All rights reserved. DRAFT. October 20, 2011
Figure
SH_208
SH_209
252)
Figure
Figure 253).
252). Push the
295