Yamaha TZ250M1 Owner's Service Manual page 80

FRONT FORK INSPECTION/
FRONT FORK TOP END ADJUSTMENT
6. Adjust:
• Wheel alignment
Turn the chain puller adjuster while paying
attention to the drive chain slack and make
adjustment while moving the rear wheel.
NOTE:
• Figure C shows that the wheel alignment has
been correctly made (b = c and d = e).
• After the adjustment, record the difference in
the graduation between the left and right
chain pullers as it will provide convenience in
your future similar adjustment.
7. Install:
• Lower cowl
EC36C000
FRONT FORK INSPECTION
1. Inspect:
• Front fork smooth action
Operate the front brake and stroke the front
fork.
Unsmooth action/oil leakage ≥ Repair or
replace.
EC36E021
FRONT FORK TOP END ADJUSTMENT
1. Hold the machine on upright position by
placing the suitable stand.
2. Remove:
• Cowling
• Induction guide (left cylinder)
• Front wheel
• Front fender
3. Adjust:
• Front fork top end
Adjustment steps:
• Loosen the pinch bolts (handlebar and
steering damper stay).
• Loosen the pinch bolts (handle crown and
under bracket).
3-27
INSP
ADJ