CARBURETOR AND REED VALVE
EC465370
Carburetor installation
1. Install:
NOTE:
Install the projection between the carburetor
joint slots.
2. Tighten:
3. Connect:
NOTE:
Install the solenoid valve lead (right cylinder)
after passing it through the hole a of the
induction cap. Refer to "CABLE ROUTING
DIAGRAM" section in the CHAPTER 2.
4. Install:
5. Install:
4-17
• Carburetor 1
• Clamp (carburetor joint) 1
2 Nm (0.2 mdkg, 1.4 ftdlb)
T
• Solenoid valve lead 1
• Induction cap 1 (left cylinder only)
• Grommet 1 (right cylinder only)
• Band 2 (right cylinder only)
ENG