Yamaha TZ250M1 Owner's Service Manual page 73

REAR BRAKE PAD INSPECTION AND REPLACEMENT
• Install the brake pads 9, pad support 0,
pad pin ¡ and cotter pin ™.
NOTE:
• Always use a new cotter pin.
™
• Temporarily tighten the pad pin at this
point.
• Install the caliper £ and tighten the pad
pin ¢.
Bolt (caliper):
35 Nm (3.5 m•kg, 25 ft•lb)
Pad pin:
18 Nm (1.8 m•kg, 13 ft•lb)
3. Inspect:
• Brake fluid level
Refer to "BRAKE FLUID LEVEL INSPEC-
TION" section.
4. Check:
• Brake lever operation
A softy or spongy feeling ≥ Bleed brake
system.
Refer to "BRAKE SYSTEM AIR BLEED-
ING" section.
EC366031
REAR BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
• Brake pad thickness a
Out of specification ≥ Replace as a set.
{
Brake pad thickness a a :
Standard
4.0 mm (0.16 in)
2. Replace:
• Brake pad
Brake pad replacement steps:
• Loosen the pad pin 1 and remove the
caliper 2.
NOTE:
Before removing the caliper from the
swingarm, loosen the pad pin.
3-20
INSP
ADJ
<Limit>
1.0 mm (0.04 in)