Yamaha TZ250M1 Owner's Service Manual page 223

HANDLEBAR
7. Install:
• Master cylinder 1
• Master cylinder bracket 2
• Bolt (master cylinder bracket) 3
NOTE:
Install the bracket so that the arrow mark a
faces upward.
8. Install:
• Starter lever 1
• Screw (starter lever) 2
NOTE:
The starter lever should be installed according
to the dimension shown.
9. Install:
• Starter cable [carburetor (left cylinder)] 1
• Starter cable [carburetor (right cylinder)] 2
To starter lever 3.
NOTE:
• Apply the lithium soap base grease on the
starter lever ends.
• Install the starter cable [carburetor (left cylin-
der)] in the upper side slit a in the starter
lever.
10.Install:
• Grip (left) 1
Apply the adhesive to the handlebar 2.
NOTE:
Before applying the adhesive, wipe off grease
or oil on the handlebar surface a with a lac-
quer thinner.
5-43
CHAS
8 Nm (0.8 mdkg, 5.8 ftdlb)
T