Yamaha TZ250M1 Owner's Service Manual page 135

CLUTCH
9. Install:
• Push rod 1
• Ball 2
NOTE:
Apply the lithium soap base grease on the
push rod and ball.
10.Install:
• Pressure plate 1
NOTE:
Align the arrow marks a on the pressure plate
the arrow marks b on the clutch boss.
11. Install:
• Clutch spring 1
• Screw (clutch spring) 2
NOTE:
Tighten the screws in stages, using a criss-
cross pattern.
12.Check:
• Push lever position
Push the push lever 1 upward until it stops.
With the push lever in this position, the rear
edge a of the push lever should be aligned
with the center of the push lever installation
bolt 2.
Not aligned ≥ Adjust.
13.Adjust:
• Push lever position
Push lever position adjustment steps:
T
• Loosen the locknut 1.
• Turn the adjuster 2 to align the rear edge
of the push lever with the center of the
push lever installation bolt.
• Tighten the locknut.
Locknut:
6 Nm (0.6 m•kg, 4.3 ft•lb)
4-37
ENG
9 Nm (0.9 mdkg, 6.5 ftdlb)
T