Yamaha TZ250M1 Owner's Service Manual page 37

CLEANING AND STORAGE
EC1B2010
STORAGE
If your machine is to be stored for 60 days or
more, some preventive measures must be
taken to avoid deterioration. After cleaning the
machine thoroughly, prepare it for storage as
follows:
1. Drain the fuel tank, fuel lines, and the car-
buretor float chambers.
2. Remove the spark plugs, pour a tablespoon
of SAE 10W30 motor oil in the spark plug
hole, and reinstall the plug. With the engine
stop switch pushed in, kick the engine over
several times to coat the cylinder walls with
oil.
3. Remove the drive chain, clean it thoroughly
with solvent, and lubricate it. Reinstall the
chain or store it in a plastic bag tied to the
frame.
4. Lubricate all control cables.
5. Block the frame up to raise the wheels off
the ground.
6. Tie a plastic bag over the exhaust pipe out-
let to prevent moisture from entering.
7. If the machine is to be stored in a humid or
salt-air environment, coat all exposed metal
surfaces with a film of light oil. Do not apply
oil to rubber parts or the seat cover.
8. Drain the cooling water completely. And
then fill the coolant and water (50%:50%) in
the engine and radiator.
NOTE:
Make any necessary repairs before the
machine is stored.
1-22
GEN
INFO