Yamaha TZ250M1 Owner's Service Manual page 224

HANDLEBAR
11. Install:
• Main switch 1
• Main switch holder 2
• Screw (main switch holder) 3
• Clutch lever holder 4
• Bolt (clutch lever holder) 5
NOTE:
The main switch and clutch lever holder should
be installed according to the dimensions
shown.
12.Install:
• Clutch cable 1
NOTE:
Apply the lithium soap base grease on the
clutch cable end.
13.Install:
• Handle crown 1
Refer to "STEERING" section.
a
14.Adjust:
• Handlebar position a
Handlebar position:
9 mm (0.35 in)
5-44
CHAS
2 Nm (0.2 mdkg, 1.4 ftdlb)
T
5 Nm (0.5 mdkg, 3.6 ftdlb)
T