Yamaha TZ250M1 Owner's Service Manual page 74

REAR BRAKE PAD INSPECTION AND REPLACEMENT
• Remove the cotter pin 3, pad pin 4, pad
support 5 and brake pads 6.
• Connect the transparent hose 7 to the
bleed screw 8 and place the suitable con-
tainer under its end.
• Loosen the bleed screw and push the
caliper piston in.
C C CAUTION:
U
Do not reuse the drained brake fluid.
• Tighten the bleed screw.
Bleed screw:
6 Nm (0.6 m•kg, 4.3 ft•lb)
• Install the brake pads 9, pad support 0,
pad pin ¡ and cotter pin ™.
NOTE:
• Always use a new cotter pin.
™
• Temporarily tighten the pad pin at this
point.
• Install the caliper £ and tighten the pad
pin ¢.
Bolt (caliper):
23 Nm (2.3 m•kg, 17 ft•lb)
Pad pin:
18 Nm (1.8 m•kg, 13 ft•lb)
3. Inspect:
• Brake fluid level
Refer to "BRAKE FLUID LEVEL INSPEC-
TION" section.
4. Check:
• Brake pedal operation
A softy or spongy feeling ≥ Bleed brake
system.
Refer to "BRAKE SYSTEM AIR BLEED-
ING" section.
3-21
INSP
ADJ