EC670000
FUEL PUMP SYSTEM
EC671000
INSPECTION STEPS
If the fuel pump will not operate, use the following inspection steps.
*1 Check fuse.
OK
*2 Check battery
OK
Check each coupler and
wire connection.
OK
*1 Check main switch.
OK
Check fuel pump stop
switch.
OK
Check fuel pump relay.
OK
Check fuel pump operation.
*1 marked : Refer to "IGNITION SYSTEM" section.
*2 marked : Refer to "BATTERY INSPECTION" section in the CHAPTER 3.
NOTE:
• Remove the following parts before inspection.
1) Cowling
A
2) Fuel tank
• Use 12V battery in this inspection.
• Use the following special tool in this inspection.
Pocket tester:
YU-03112/90890-03112
FUEL PUMP SYSTEM
No good
No good
No good
No good
No good
No good
No good
Fuel pump coil
Check fuel pump.
3) Seat
4) Induction cap (left cylinder)
6-16
ELEC
Replace fuse and
check wireharness.
Recharge or replace.
Repair or replace.
No good
OK
No good
Replace.
Replace.
Replace.
Replace.
Replace.