Yamaha TZ250M1 Owner's Service Manual page 222

HANDLEBAR
2. Install:
• Throttle cable [carburetor (left cylinder)] 1
• Throttle cable [carburetor (right cylinder)] 2
To grip cap (lower) 3.
NOTE:
Install the throttle cable [carburetor (left cylin-
der)] in the grip side slit a in the grip cap
(lower).
3. Install:
• Throttle 1
NOTE:
Apply the lithium soap base grease on the
throttle grip sliding surface.
4. Install:
• Throttle cable [carburetor (left cylinder)] 1
• Throttle cable [carburetor (right cylinder)] 2
To tube guide 3.
NOTE:
• Apply the lithium soap base grease on the
throttle cable ends and tube guide cable wid-
ing portions.
• Install the throttle cable [carburetor (left cylin-
der)] in the grip side slit a in the tube guide.
5. Install:
• Grip cap (upper) 1
• Bolt (grip cap) 2
NOTE:
• Align the contacting surface a of the grip cap
(upper) with the punch mark b on the han-
dlebar.
• Tighten the bolts so that the upper side con-
tacting surface c is closed.
6. Adjust:
• Throttle grip free play
Refer to "THROTTLE CABLE ADJUST-
MENT" section in the CHAPTER 3.
5-42
CHAS