Yamaha TZ250M1 Owner's Service Manual page 22

Part number
YM-01425, 90890-01425 Damper rod holder
Use this tool to remove and install the damper rod.
YM-01434, 90890-01434 Rod holder
This tool is used to hold the fork spring.
90890-01435 Rod puller attachment
YM-01437, 90890-01437 Rod puller
These tools are used to pull up the fork damper rod.
YM-01441, 90890-01441 Fork spring compressor
This tool is used to compress the fork spring.
YM-01442, 90890-01442 Fork seal driver
This tool is used when install the fork oil seal.
YM-01455, 90890-01455 Pivot shaft wrench
YM-01476, 90890-01476 Pivot shaft wrench adapter
These tools are used to loosen or tighten the pivot
adjust bolt.
YU-03112, 90890-03112 Yamaha pocket tester
Use this tool to inspect the coil resistance, output
voltage and amperage.
YM-91042, 90890-04086 Clutch holding tool
This tool is used to hold the clutch when removing or
installing the clutch boss securing nut.
YM-34487 Dynamic spark tester
90890-06754 Ignition checker
This instrument is necessary for checking the ignition
system components.
ACC-11001-05-01 Quick gasket
90890-85505 YAMAHA Bond No. 1215
This sealant (Bond) is used for crankcase mating
surface, etc.
Tool name / How to use
®
1-7
SPECIAL TOOLS
Illustration
YM-01425
YM-01434
YM-01437
YM-01441
YM-01442
YM-01455
YM-01476
YU-03112
YM-91042
YM-34487
ACC-11001-05-01
GEN
INFO
90890-01425
90890-01434
90890-01435
90890-01437
90890-01441
90890-01442
90890-01455
90890-01476
90890-03112
90890-04086
90890-06754
90890-85505