Charging System - Yamaha TZ250M1 Owner's Service Manual

EC680000

CHARGING SYSTEM

EC681000
INSPECTION STEPS
If the battery is not charged, use the following inspection steps.
*1 Check fuse.
OK
*2 Check battery
OK
Check each coupler and
wire connection.
OK
Check charging voltage.
No good
*1 Check CDI magneto.
OK
Check voltage regulator.
*1 marked : Refer to "IGNITION SYSTEM" section.
*2 marked : Refer to "BATTERY INSPECTION" section in the CHAPTER 3.
NOTE:
• Remove the following parts before inspection.
A
1) Cowling
2) Fuel tank
• Use the following special tool in this inspection.
Pocket tester:
YU-03112/90890-03112
CHARGING SYSTEM
No good
No good
No good
OK
No good
Source coil
No good
6-7
ELEC
Replace fuse and
check wireharness.
Recharge or replace.
Repair or replace.
Charging system is
good.
Replace.
Replace.