Yamaha TZ250M1 Owner's Service Manual page 147

SHIFT SHAFT
EC4F5411
Transmission housing
1. Apply:
• Transmission oil
On the bearing (crankcase lower) and
impeller shaft.
2. Install:
• Dowel pin 1
• Transmission housing 2
NOTE:
When installing the transmission housing, turn
the oil pump driven gear 3 until the key end a
of the oil pump gear shaft 4 is in the recess b
of the impeller shaft 5.
3. Install:
• Bolt {transmission housing [L=40 mm (1.57 in)]} 1
• Bolt {transmission housing [L=30 mm (1.18 in)]} 2
NOTE:
• Tighten the bolts in stages, using a crisscross
pattern.
• Apply the transmission oil on the thread and
contact surface of the bolt (transmission
housing).
4. Install:
• Plain washer 1
• Spacer 2
• Shift arm 3
• Bolt (shift arm) 4
NOTE:
• Make sure that the joint rod distance a is
104.5~106.5 mm (4.1~4.2 in).
• Install the shift arm so that the shift pedal cen-
ter b is highest without exceeding the inside
line c of the footrest bracket.
4-49
ENG
16 Nm (1.6 mdkg, 11 ftdlb)
T
16 Nm (1.6 mdkg, 11 ftdlb)
T
14 Nm (1.4 mdkg, 10 ftdlb)
T