Yamaha TZ250M1 Owner's Service Manual page 134

CLUTCH
6. Install:
• Lock washer 1N
• Nut (clutch boss) 2
NOTE:
Use the clutch holding tool 3, 4 to hold the
clutch boss.
C C CAUTION:
Align the projections on the lock washer
B
with the holes a a in the clutch boss.
Clutch holding tool:
YM-91042 . . . . . . . . . . . . . . . .3 3
90890-04086 . . . . . . . . . . . . .4 4
A For USA and CDN
B Except for USA and CDN
7. Bend the lock washer 1 tab.
8. Install:
• Friction plate (yellow) 1
• Clutch plate 2
• Friction plate (brown) 3
NOTE:
• Install the clutch plates and friction plates
alternately on the clutch boss, starting with a
friction plate and ending with a friction plate.
• Yellow colored friction plates are used for the
first and final.
• This machine is equipped with a dry type
clutch. Be sure to clean with solvent or
replace if grease or oil contacts either clutch
or friction plates.
4-36
ENG
75 Nm (7.5 mdkg, 54 ftdlb)
T