Yamaha TZ250M1 Owner's Service Manual page 51

1 Fuel pump lead
2 Clamp
3 Fuse holder
4 Servomotor
5 Front brake hose (right)
6 YPVS cable 1, 2 (right cylinder)
7 Clutch cable
CABLE ROUTING DIAGRAM
A Clamp the fuel hose and clutch cable. Position the upside ends of the
clamp inside of the seat rail.
B Clamp the radiator hose 3 and ignition coil lead.
C Clamp the radiator hose 3 and YPVS cable (right cylinder).
D Do not cut the end of the clamp.
E Connect the left cylinder YPVS cables (silver cables) to the inner YPVS
servomotor pulley and right cylinder YPVS cables (black cables) to the
outer. The sleeved cables must be connected to the top side (open side)
of the YPVS servomotor.
F Position the ends of the clamp on the under portion of the under brack-
et.
G Be sure the brake hose is not twisted.
2-14
SPEC