Yamaha TZ250M1 Owner's Service Manual page 114

CARBURETOR AND REED VALVE
9. Install:
10.Install:
NOTE:
• Install the throttle cable (right cylinder) after
• While compressing the spring, connect the
• Align the projection b on the ring with the
11. Install:
NOTE:
• Install the fuel hose (right cylinder) after pass-
• After installing, check the throttle grip for
4-16
• Collar 1
• Jet needle 2
• Spring guide 3
• Spring 4
• Needle holder 5
To throttle valve 6.
• Throttle cable 1
• Mixing chamber top 2
• Spring (throttle valve) 3
• Ring 4
• Throttle valve 5
passing it through the hole a of the induction
cap. Refer to "CABLE ROUTING DIAGRAM"
section in the CHAPTER 2.
throttle cable.
groove c in the needle holder 6.
• Mixing chamber top 1
• Screw (mixing chamber top) 2
2 Nm (0.2 mdkg, 1.4 ftdlb)
T
• Fuel hose 3
To carburetor 4.
ing it through the hole a of the induction cap.
Refer to "CABLE ROUTING DIAGRAM" sec-
tion in the CHAPTER 2.
smooth movement.
ENG