Yamaha TZ250M1 Owner's Service Manual page 238

SWINGARM
4. Install:
• Swingarm 1
• Pivot shaft 2
NOTE:
• Apply the lithium soap base grease on the
pivot shaft.
• Insert the pivot shaft from left side.
5. Tighten:
• Pivot adjust bolt 1
NOTE:
Use the pivot shaft wrench 2 and pivot shaft
wrench adapter 3 to tighten the pivot adjust
bolt.
C
Pivot shaft wrench:
YM-01455/90890-01455
Pivot shaft wrench adapter:
YM-01476/90890-01476
6. Install:
• Plain washer 1
• Nut (pivot shaft) 2
7. Check:
• Swingarm side play a
Free play exists ≥ Check side clearance.
• Swingarm up and down movement b
Unsmooth movement/Binding/Rough spots
≥ Grease or replace bearings, bushes and
collars.
8. Install:
• Bolt (rear shock absorber – relay arm) 1
• Nut (rear shock absorber – relay arm) 2
NOTE:
Apply the lithium soap base grease on the bolt.
5-58
CHAS
5 Nm (0.5 mdkg, 3.6 ftdlb)
T
115 Nm (11.5 mdkg, 85 ftdlb)
T
34 Nm (3.4 mdkg, 24 ftdlb)
T