Replacing Headlight Holder (Led) - Invacare Storm4 Series Service Manual

Invacare® Storm⁴ Series
Removing Headlight
1. Remove rear and centre shrouds. See 6.6.1 Replacing
Rear Shroud, page 21 and 6.6.2 Replacing Centre Shroud,
page 22.
2. Take exact note of positions of all cables and sockets
that cables are connected to. Mark connectors and
sockets or take a photograph.
3. Open cable clamps (1), remove all tie wraps and pull
cable out of mobility device.
4. Disconnect cable of affected headlight from light board
(2).
5. Loosen screw (1) and remove headlight from holder.
6. Replace headlight.
Installing Headlight
1. Install parts in reverse order.
2. Install cables carefully and secure them with cable
clamps and tie wraps.
3. Tighten screws finger-tight.
4. Adjust headlight roughly using ratchet plate as a guide.
The user can carry out final adjustment following user
manual.
5. Test all functions.

6.11.3 Replacing Headlight Holder (LED)

• 4 mm Allen key
• 8 mm wrench
• Oblique pliers
• Tie wraps
50
Fig. 6-46
Fig. 6-47
1555830-C