7. Remarks
Maintaining Your Machine
If the exposure glass, scanning glass, or ADF is dirty, copy clarity may be reduced. Clean these parts if
they are dirty.
• Do not use chemical cleaners or organic solvents, such as thinner or benzene. If such substances get
inside the machine or melt plastic parts, a failure might occur.
• Do not clean parts other than those explicitly specified in this manual. Other parts should only be
cleaned by your service representative.
How to maintain
Cleaning the machine: Wipe the machine with a soft, dry cloth. If this does not remove the dirt, wipe
the machine with a damp and tightly wrung cloth. If a damp cloth still does not remove the dirt, try
using a mild detergent. Wipe the machine with a dry cloth to remove the moisture, after using a damp
cloth.
Cleaning the Exposure Glass
This section describes how to clean the exposure glass and the scanning glass.
7
1.
Wipe the exposure glass and the scanning glass.
1. Scanning glass
2. Exposure glass
Cleaning the ADF
This section describes how to clean the ADF.
108
BJA048S