Removing A Two-Position Scsi Disk Drive Bay - IBM F80 Service Manual

If you are installing:
v A two-position SCSI disk drive bay, continue with "Removing a Two-Position SCSI
Disk Drive Bay."
v A six-position SCSI (SES) or SSA hot plug disk drive bay, go to "Removing
Six-Position SCSI (SES) or SSA Disk Drive Bays" on page 358.

Removing a Two-Position SCSI Disk Drive Bay

To remove a two-position SCSI disk drive bay, use the following procedure:
1. If you have not already done so, shut down the system as described in "Stopping
the System Unit" on page 316.
2. If you have not already done so, remove the front and right side covers as
described in "Removing the Covers" on page 311.
3. Remove the drives from the two-position disk drive bay, as described in "Removing
a Disk Drive from the Two-Position Disk Drive Bay" on page 371.
4. Remove the screws holding the two-position disk drive bay in the system.
5. Label and disconnect the SCSI cable connectors from the backplane.
6. Slide the disk drive bay cage out of the system as shown in the following diagram.
356
Service Guide
D14
D13
D D D
D D D
0 1
0 1 1
0
7
8 0 1 2
9
D D D D
D D
0 0 0
0 0 0
1 5
2 4 6
3
DB3
DB2
DB1