Table of Contents
Advertisement
2. Install a FRU (adapter) and connect any cables and devices that were attached to
it.
Note: If the FRU you installed requires supplemental media, use the Process
3. Connect the system unit power cable to the wall outlet and wait for OK on the
operator panel display
4. Turn on the power.
5. After the keyboard indicator is displayed, press the number 5 key on the directly
attached keyboard or the number 5 key on an ASCII terminal keyboard.
6. Enter the appropriate password when you are prompted to do so.
Is the "Please define the System Console" screen displayed?
NO
YES
Step 1540-18
The last FRU installed or one of its attached devices is probably defective.
1. Make sure the diagnostic CD-ROM disc is inserted into the CD-ROM drive.
2. Turn off the power and unplug the system unit power cable from the wall outlet.
3. Starting with the last installed adapter, disconnect one attached device and cable.
4. Connect the system unit power cable to the wall outlet and wait for OK on the
operator panel display.
5. Turn on the power.
6. If the Console Selection screen is displayed, choose the system console.
7. After the keyboard indicator is displayed, press the number 5 key on the directly
attached keyboard or the number 5 key on an ASCII terminal keyboard.
8. Enter the appropriate password if prompted to do so.
Is the "Please define the System Console" screen displayed?
NO
70
Service Guide
Supplemental Media task to load the supplemental media first.
Go to "Step 1540-18."
Repeat this step until all of the FRUs (adapters) are installed.
Go to "MAP 410: Repair Checkout" in RS/6000 and Eserver pSeries
Diagnostic Information for Multiple Bus Systems.
Repeat this step until the defective device or cable is identified or all the
devices and cables have been disconnected.
If all the devices and cables have been removed, then one of the FRUs
remaining in the system unit is defective.
To test each FRU, exchange the FRUs in the following order:
1. Adapter (last one installed)
2. System board (see note 3 on page 41)
If the symptom did not change and all the FRUs have been exchanged, call
your service support person for assistance.
Advertisement
Table of Contents
