Removing A Sas Hard Disk Drive - IBM BladeCenter HS20 7981 Problem Determination And Service Manual

Removing a SAS hard disk drive

To remove a SAS hard disk drive, complete the following steps:
Hard
drive
release
lever
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Shut down the operating system, turn off the blade server, and remove the
3. Remove the blade server cover (see "Removing the blade server cover" on
4. Locate the hard disk drive that is to be removed (SAS ID 0 or SAS ID 1).
5. While pulling the blue release lever at the front of the hard disk drive tray, slide
6. The SAS drive tray can be removed by removing the four screws that secure it
7. If you are instructed to return the SAS drive, follow all packaging instructions,
62
BladeCenter HS20 Type 7981: Problem Determination and Service Guide
SAS ID 1
SAS ID 0
Hard drive
release
lever
on page 55.
blade server from the BladeCenter unit. See "Removing the blade server from a
BladeCenter unit" on page 57 for instructions.
page 59 for instructions).
the drive out of the SAS connector and disengage it from the drive tray.
to the system board and then lifting the tray from the system board.
and use any packaging materials for shipping that are supplied to you.