Table of Contents
Advertisement
11. Select Replace/Remove a PCI Hot-Plug Adapter and press Enter. The
Replace/Remove a PCI Hot-Plug Adapter menu displays.
12. Move the cursor to select the adapter that you are removing and press Enter.
13. Press the Tab key until the entry field displays the replace operation and then
press the Enter key. Follow the instructions that display on the screen until you are
instructed to remove the adapter.
14. When you are instructed to remove the adapter from the adapter slot, disconnect
any cables that are connected to the adapter being removed
15. Turn the locking latch, and lift the plastic stop for the adapter.
16. Carefully grasp the adapter by the edges, and pull it straight out from the I/O
board.
17. Replace the adapter in the adapter slot. Carefully grasp the adapter by the edges,
and align the adapter in the slot guides. Insert the adapter fully into the adapter
slot connector. If you are installing a full-length adapter, ensure that both ends of
the adapter engage the card guides.
18. Lower the plastic stop over the adapter bracket, and rotate the locking latch
clockwise until it clicks into the locked position. Some full-length cards can be
supported by rotating the blue adapter latch on the right end of the adapter divider
counterclockwise.
19. Connect appropriate cables and devices to the adapter.
Chapter 9. Removal and Replacement Procedures
335
Advertisement
Table of Contents
