IBM F80 Service Manual page 157

Table 7. Service Processor Error Codes (continued)
Error Code Description
4066 00A6 Scan interface basic assurance tests
detected no usable memory
4066 00A7 Scan interface basic assurance tests
detected hardware problem
4066 00B0 Scan interface basic assurance tests
detected bus controller lock-unlock
failure
4066 00B1 Scan interface basic assurance tests
detected bus controller failure
4066 00B7 Scan interface basic assurance tests
detected insufficient hardware
resources to continue IPL
4066 0100 Scan interface basic assurance tests
detected memory riser card fault
4066 0101 Scan interface basic assurance tests
detected memory DIMM fault
4066 0102 Scan interface basic assurance tests
detected memory DIMM fault
4066 0103 Scan interface basic assurance tests
detected memory DIMM fault
4066 0104 Scan interface basic assurance tests
detected memory DIMM fault
4066 010D Scan interface basic assurance tests
detected memory DIMM fault
4066 0111 Scan interface basic assurance tests
detected memory DIMM fault
4066 0112 Scan interface basic assurance tests
detected memory DIMM fault
Action/ Possible Failing FRU
1. Ensure that memory is properly
installed
2. If more than one DIMM is called
out, go to the service processor
Memory
Configuration/Deconfiguration
Menu to verify memory DIMMs
state. See "Memory
Configuration/Deconfiguration
Menu" on page 268 for more
information.
3. Go to "MAP 1540: Minimum
Configuration" on page 57
4. If the problem is not fixed, call
service support.
Go to "MAP 1540: Minimum
Configuration" on page 57.
System board, Location: P1
System board, Location: P1
This error code appears after the
initial testing by the service processor
firmware on the processors and
memory completed successfully, but
a problem occurred when the
firmware tried to communicate
outside the processor and memory
complex. Suspect a problem with the
backplane, location: P1.
Memory riser card Location: P1-M2
Memory DIMM Location: P1-M2.15
Memory DIMM Location: P1-M2.1
Memory DIMM Location: P1-M2.16
Memory DIMM Location: P1-M2.2
Memory DIMM Location: P1-M2.1 x4
Memory DIMM Location: P1-M2.13
Memory DIMM Location: P1-M2.3
Chapter 5. Error Code to FRU Index
139