Table of Contents
Advertisement
4. Lift the locking handle and push it in at the top of the power supply until it locks the
power supply into position.
5. Plug in the power cord and turn on the system. The redundant features will be
recognized as the system powers up.
Memory Riser Card and Processor Card
Attention:
Static-Sensitive Devices" on page 310).
Note: Installing a processor card into your system unit may require updating the
Removing a Memory Riser Card or One-Way Processor Card
1. If you have not already done so, shut down the system as described in "Stopping
the System Unit" on page 316.
2. If you have not already done so, unplug the system unit power cable from the
electrical outlet.
3. If you have not already done so, remove the covers as described in "Removing the
Covers" on page 311.
4. Remove the processor and memory riser card cover as described in "Removing
Processor and Memory Riser Card Cover" on page 315.
5. The card is secured in place with camming latches at each end. Open the card
latches by rotating them out until the card is pulled out of the connector on the
system board.
342
Service Guide
All cards are sensitive to electrostatic discharge (see "Handling
firmware. A diskette or CD-ROM is included with your new processor card if that
is required.
Advertisement
Table of Contents
