IBM F80 Service Manual page 345

2. Install the disk drive in the drive slot. Align the disk drive with the drive slot rails,
and slide the disk drive into the slot until it contacts the backplane at the rear of
the drive bay.
3. Push the disk drive lever up and to the rear to lock the disk drive.
4. Log in as root user.
5. At the command line, type smitty.
6. Select Devices.
7. Select Install/Configure Devices Added After IPL and press Enter. Successful
configuration is indicated by the OK message displayed next to the Command field
at the top of the screen.
8. Press F10 to exit smitty.
9. Replace the front cover as described in "Replacing Covers" on page 314.
10. Refer to the AIX System Management Guide: Operating System and Devices to
configure the new SSA disk drive. This publication is located on the AIX
Documentation CD. Access the documentation information by loading the
documentation CD onto the hard disk or by mounting the CD in the CD-ROM
drive.
Chapter 9. Removal and Replacement Procedures
327