Table of Contents
Advertisement
Table 7. Service Processor Error Codes (continued)
Error Code
Description
406C 00A1
IPL MOPs detected system firmware
fault
406C 00A2
IPL MOPs detected service
processor firmware (PRD) fault
406C 00A3
IPL MOPs detected memory plugging
fault
406C 00A4
IPL MOPs detected application
caused fault
406C 00A5
IPL MOPs detected invalid system
configuration
406C 00A6
IPL MOPs detected no usable
memory
406C 00A7
IPL MOPs detected hardware
problem
406C 00B0
IPL MOPs detected bus controller
lock-unlock failure
406C 00B1
IPL MOPs detected bus controller
failure
406C 00B7
IPL MOPS detected insufficient
hardware resources to continue IPL
406C 0100
IPL MOPs detected memory riser
card fault
406C 0101
IPL MOPs detected memory DIMM
fault
Action/ Possible Failing FRU
1. Check for AIX updates
2. Check for system firmware
updates
Update system firmware
Go to "MAP 1540: Minimum
Configuration" on page 57.
Application software
Verify that system components are
supported and properly installed
1. Ensure that memory is properly
installed
2. If more than one DIMM is called
out, go to the service processor
Memory
Configuration/Deconfiguration
Menu to verify memory DIMMs
state. See "Memory
Configuration/Deconfiguration
Menu" on page 268 for more
information.
3. Go to "MAP 1540: Minimum
Configuration" on page 57
4. If the problem is not fixed, call
service support.
Go to "MAP 1540: Minimum
Configuration" on page 57.
System board, Location: P1
System board, Location: P1
This error code appears after the
initial testing by the service processor
firmware on the processors and
memory completed successfully, but
a problem occurred when the
firmware tried to communicate
outside the processor and memory
complex. Suspect a problem with the
backplane, location: P1.
Memory riser card Location: P1-M2
Memory DIMM Location: P1-M2.15
Chapter 5. Error Code to FRU Index
167
Advertisement
Table of Contents
