Step 2. Configuring Basic Settings With The Cli - Juniper JUNOS J Series Quick Start Manual

4.
5.
6.
7.
For complete instructions, see the JUNOS Enhanced Services J-series Services Router
Getting Started Guide.

Step 2. Configuring Basic Settings with the CLI

In CLI configuration mode, you use the
delete
configuration on the router until you use the
To configure basic settings with the CLI:
1.
2.
On the PC or laptop, start the terminal emulation program (such as Microsoft
Windows HyperTerminal), select the
settings: 9600 (bits per second),
(flow control).
none
Press the POWER button on the router, and verify that the
green.
Wait for the system to boot, and when presented with a login prompt, log in as
, and press Enter at the
root
When you have been authenticated through the CLI, you enter the UNIX shell:
routername (ttyd0)
login: root
Password:
JUNOS 8.5R1 20070628.0 built 08:11:01
root@%
At the % prompt, type the
to an angle bracket (>) when you enter CLI operational mode.
root@% cli
root>
command to disable them. The commands you enter do not update the active
From the CLI, enter configuration mode:
root> configure
root#
Set the IP addresses of the built-in Ethernet ports. For example:
root# set interfaces ge-0/0/0 unit 0 family inet address 1.1.2.31/24
root# set interfaces ge-0/0/1 unit 0 family inet address 1.6.2.1/24
root# set interfaces ge-0/0/2 unit 0 family inet address 2.8.3.1/24
root# set interfaces ge-0/0/3 unit 0 family inet address 9.1.4.1/24
The unit number is the logical interface number. IP addresses are configured on
the logical interface. Setting the protocol family to
of IPv4 addresses.
Basic Connection and Configuration with the CLI
port, and configure the following port
COM
8 (data bits), none (parity),
prompt.
Password
UTC
command and press Enter. The prompt changes
cli
set command to enable features, and the
command.
commit
inet
Basic Connection and Configuration with the CLI
1 (stop bits), and
POWER LED turns
specifies the routing table
13