Mounting An Ex4300 Switch In A Recessed Position In A Rack Or Cabinet; Mounting An Ex4300 Switch On A Wall - Juniper EX4300 Hardware Manual
Hide thumbs
Also See for EX4300:
- Hardware manual (415 pages) ,
- Quick start manual (11 pages) ,
- Manual (9 pages)
Table of Contents
Advertisement
Related
Documentation
Mounting an EX4300 Switch in a Recessed Position in a Rack or Cabinet
Related
Documentation
Mounting an EX4300 Switch on a Wall
Copyright © 2017, Juniper Networks, Inc.
NOTE:
We recommend that you install cover panels in the unused uplink
module and power supply slots.
Connecting Earth Ground to an EX Series Switch on page 179
Connecting AC Power to an EX4300 Switch on page 185
Connecting DC Power to an EX4300 Switch on page 188
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 215
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 218
Mounting an EX4300 Switch in a Recessed Position in a Rack or Cabinet on page 173
Rack-Mounting and Cabinet-Mounting Warnings on page 294
You can mount an EX4300 switch in a recessed position on two posts of either a two-post
rack or a four-post rack such that the switch is recessed inside the rack from the rack
front by 2 inches. To mount the switch in a recessed position, use the front-mounting
brackets provided in the separately orderable four-post rack-mount kit.
Reasons to mount the switch in a recessed position include:
You are mounting the switch in a cabinet and the cabinet doors do not close completely
unless the switch is recessed.
The switch you are mounting has an uplink module with transceivers installed in it—the
transceivers in the uplink module ports protrude from the front of the switch.
To mount the switch in a recessed position, on two-posts or on four-posts, follow the
instructions in
"Mounting an EX4300 Switch on Two Posts of a Rack or Cabinet" on
page 167
or
"Mounting an EX4300 Switch on Four Posts of a Rack or Cabinet" on page
Connecting Earth Ground to an EX Series Switch on page 179
Rack-Mounting and Cabinet-Mounting Warnings on page 294
You can mount an EX4300 switch on a wall by using the separately orderable wall-mount
kit.
Before mounting the switch on a wall:
Verify that the site meets the requirements described in
for EX4300 Switches" on page
"Site Preparation Checklist
87.
Chapter 11: Installing the Switch
169.
173
Advertisement
Table of Contents
