Assigning Avaya P330'S Ip Stack Address; Changing The Ip Address Using Command Line Interface (Cli, Terminal Emulation) - Avaya P333T User Manual

6 At the prompt, type:
set interface ppp enable
The CLI responds with the following:
Entering the Modem mode within 60 seconds...
Please check that the proprietary modem cable is plugged
into the console port
7 Use the DB-25 to RJ45 connector to plug the RJ-45 cable to the modem's DB-25
connector. Plug the other end of the cable Rj-45 connector to the Avaya P330
console's RJ-45 port.
8 The Avaya P330 enters modem mode.
9 You can now dial into the switch from a remote station, and open a Telnet
session to the PPP interface IP address.

Assigning Avaya P330's IP Stack Address

Note: All Avaya P330 switches are shipped with the same default IP address. In
order to ensure that the stack has its own unique IP address in the network, you
must change the IP address of the Master Avaya P330 switch in the stack .

Changing the IP Address using Command Line Interface (CLI, Terminal Emulation)

Use the CLI to assign the Avaya P330 stack an IP address and net mask. The
CajunView station may establish communications with the stack once this address
had been assigned and the stack inserted into the network.
1 Establish a serial connection by connecting a terminal to the Master Avaya P330
switch as described in the "Command Line Interface" chapter.
2 When the "Welcome to P330" menu appears and you are prompted for a Login
Name, enter the default name root
3 When you are prompted for a password, enter the password root. You are
now in Supervisor Level
4 At the prompt, type:
set interface inband <vlan> <ip_address> <netmask>
Replace <vlan>, <ip_address> and <netmask> with the VLAN,
IP address and net mask of the stack.
5 Press Enter to save the IP address and net mask.
6 At the prompt, type reset and press Enter to reset the stack. After the Reset,
log in again as described above.
7 At the prompt, type set ip route <dest> <gateway> and replace <dest>
and <gateway> with the destination and gateway IP addresses.
8 Press Enter to save the destination and gateway IP addresses.
Avaya P333T User's Guide
Chapter 4 Installation and Setup
29