Ip Rip Send-Receive-Mode Command - Avaya P333R User Manual

ip rip send-receive-mode Command

Use the ip rip send-receive-mode command to set the RIP Send and
Receive mode on an interface. The default state is talk-listen.
The syntax for this command is:
ip rip send-receive <mode>
The possible RIP Send and Receive mode on an interface are:
talk-listen
talkdefault-listen
listen-only
Example:
To set the RIP Send and Receive mode on the interface "marketing" to be listen-only:
Router-N(config-if:marketing)# ip rip send-receive listen-only
ip rip default-route-mode Command
Use the ip rip default-route-mode command to enable learning of the
default route received by the RIP protocol. The default state is talk-listen.
The syntax for this command is:
ip rip default-route-mode <mode>
The possible default route modes on an interface are:
talk-listen
talk-only
Avaya P333R User's Guide
Chapter 7
Set RIP to receive and transmit updates on the
interface.
Set RIP to receive updates on the interface and send
only a default route.
Set RIP to only receive updates on the interface and
not transmit them.
Set RIP to send and receive default route updates on
the interface.
Set RIP to send but not receive default route updates
on the interface.
Cajun Campus CLI - Layer 3
183