Removing The Cooling Fan; Disconnect The Ac Inlet - Epson Stylus PRO 7500 Service Manual

EPSON Stylus Pro 7500

REMOVING THE COOLING FAN

1. 1. Take out the 2 white screws (CP(W): M3 x 25) used to fasten the cooling fan, then
remove the cooling fan.
NOTE: The cooling fan's installation direction (the sticker surface and harness
routing direction) is fixed, so caution should be exercised.
Screws (M3 x 25)
Figure 4-27. Removing the Cooling Fan
Disassembly & Assembly

DISCONNECT THE AC INLET

1. Take out the 2 white screws (countersunk head screws: M3 x 6) used to fasten the AC
inlet, then remove the AC inlet.
NOTE: The AC inlet's installation direction is fixed, so caution should be
exercised. (The sticker surface faces up).
Screws (M3 x 6)
Cooling Fan
Disassembly Flow
AC Inlet
Figure 4-28. Removing the AC Inlet
Revision A
111