Resetting Nvram; Figure 9-15 Nvram Test Menu - Tektronix Phaser 340 Service Manual

Resetting NVRAM

Resetting NVRAM returns all the image processor's NVRAM-stored parameters
to their factory defaults except the print count (for images processed through the
image processor) and the Adobe firmware serial number. If you do not wish to
reset the NVRAM-stored parameters of an installed Phaser Share card, then
remove the card before performing this procedure.
Caution When servicing the printer, before turning on the printer, you
should always make sure that the head tilt cam gear is latched by
the head tilt solenoid and that the head tilt cam gear is disengaged
(via its missing teeth) to the drive gear.
To reset the printer to its factory-default values, follow this procedure:
1. With the printer in its Ready state, press Menu.
2.
Scroll to the Service Support menu item.
3. Press Menu and Exit to enter the special service menu.
4. Scroll to the menu item Reset NVRAM.
5.
Press OK to reset NVRAM.
Alternately, you can also use the PC diagnostics to selectively return either the
print engine NVRAM contents or the PostScript NVRAM contents to their
factory default values as shown in the following illustration

Figure 9-15 NVRAM Test menu

Checks and Adjustments
Service Manual 9-21
9