Resetting Nvram - Tektronix PHASER 560 Service Manual

9
Checks and Adjustments

Resetting NVRAM

9-12 Phaser 560 Color Printer
Downloaded from www.Manualslib.com
Resetting NVRAM returns all the image processor's NVRAM-stored parameters
to their factory defaults except the print counts and the Adobe firmware serial
number.
Caution Resetting NVRAM will also reset the network card's NVRAM. If
this is not desired, remove the network card from the printer before
performing the NVRAM reset.
To reset the image processor to its factory default values, follow this procedure:
1. Turn the printer off.
2. Press and hold the front panel Buttons 1 (Exit) and 4.
3. Turn the printer on.
4. When the front panel displays the message NVRAM Default, release
Buttons 1 and 4.
5.
At this point the message password? will be displayed. Within
10 seconds, press Buttons 1 (Exit) and 3 at the same time. The
NVRAM parameters will be reset to their factory default values. If
you do not press buttons 1 and 3 in the allotted time, the NVRAM will
not be changed.
manuals search engine