Resetting Postscript Nvram - Tektronix Phaser 380 Service Manual

Viewing NVRAM contents

Resetting PostScript NVRAM

Use the PC diagnostics' NVRAM Test menu to select a menu item that lets you
view the contents of Print Engine NVRAM.
Figure 9-22 Viewing NVRAM contents
Resetting PostScript NVRAM returns all the image processor's NVRAM-stored
parameters to their factory defaults except the print count (for images processed
through the image processor) and the Adobe firmware serial number. If you do
not wish to reset the NVRAM-stored parameters of an installed Phaser Share
card, then remove the card before performing this procedure.
To reset the printer to its factory-default values, follow this procedure:
1.
With the printer in its Ready state, press Menu.
2. Scroll to the Service Support menu item.
3. Press Menu and Exit to enter the special service menu.
4.
Scroll to the menu item Reset NVRAM.
5. Press OK to reset NVRAM.
Alternately, you can also use the PC diagnostics to return the PostScript
NVRAM contents to their factory default values.
Checks and Adjustments
Service Manual 9-37
9