Figure 8-7 Removing The Power Supply - Tektronix Phaser 340 Service Manual

7. Remove the six screws securing the power supply in place. Remove
the power supply.

Figure 8-7 Removing the power supply

Reverse these steps to install the power supply. Be sure that the sheet metal
alignment guides in the back and bottom of the power supply align with the
notches cut out in the power supply circuit board. Install the power supply's
rear screw first and then the side screws to secure the power supply in place.
Refer to Appendix C "Wiring Diagrams" for the proper method of routing
wiring between the solenoid valve and the power supply.
Field Replaceable Unit Disassembly/Assembly
Disconnect
heater wiring
harness
Service Manual
8
Compression
washer
Power supply
9100-37
8-13