Setting Up The Printer; Figure 2-2 Unlocking The Transit Restraint Lock - Tektronix Phaser 340 Service Manual

2
Installing the Printer and Drivers

Setting up the printer

2-8 Phaser 340 Color Printer
Installing the printer is explained in detail in the Phaser 340 Color Printer User
Manual . The following is a brief list of the steps you follow to unpack and set up
the printer.
1.
Remove the printer from its shipping box and place it in its working
location. If the Lower Paper Tray Assembly was also purchased, place
the Lower Paper Tray Assembly in the working location and then
install the printer on top of it.
2. Install the paper tray(s) in the printer.
3.
Unlock the transit restraint lock on the right side of the printer.

Figure 2-2 Unlocking the transit restraint lock

4. AC voltage selection:
side of the printer. Ensure that it is set to the correct voltage for the
customer's installation (either 115 VAC or 220 VAC).
5. Ensure that the power switch is off .
6. Plug the printer's power cord into the printer's AC receptacle. Plug
the other end into an appropriate AC power outlet.
Locate the AC voltage select switch on the right
3
2
9101-03