Accumulator
Tools required
Magnetic screwdriver
T-20 TORX tip
T-15 TORX tip
1.
Turn off the printer and remove the power cord.
2.
Remove the top, left-side and right-side covers as explained in the
earlier topic, "Cabinet panels and covers" on page 8-4.
3.
Remove the ink loader as detailed earlier in the topic, "Ink loader" on
page 8-6.
4.
Disconnect the wiring harnesses leading to the rear fan.
5.
Remove the 12 screws securing the rear plate to the engine frame. Set
the rear plate and attached rear fan aside.
6.
Disconnect the two vacuum hoses leading to the accumulator.
7.
Remove the two screws securing the accumulator in place. Remove
the accumulator.
Remove two
screws
Accumulator
Vacuum
hoses
Figure 8-9 Removing the accumulator
Field Replaceable Unit Disassembly/Assembly
Service Manual
8
9100-41
8-15