Service Manual - Tektronix Phaser 340 Service Manual

Configuration page
Table 2-1 Configuration page settings
Parameter Description
Printer type The name of the product.
Printer name The current name of the printer as
seen on a network.
Pages printed Total number of prints processed
through the image processor.
PostScript FW Tektronix version number of the
version number PostScript firmware running on the
printer's 29K processor.
Print engine FW Tektronix version number of the engine
version number firmware running on the printer's 68K
processor. Read from ROM and
stored in NVRAM.
To provide further diagnostic information, the printer can print a configuration
page. The configuration page lists the values that the printer stores in its
NVRAM as well as those of an installed network card's NVRAM. These values
can be informative when troubleshooting the printer, particularly networked
operations. To print a configuration page, while the printer is powered-up and
idle, scroll through the front panel menu and select Configuration Page from the
Test Prints menu. Refer to the Section 9 topic, "Printing the configuration page"
on page 9-7.
The configuration page gives the following information:
General information about the printer, such as print count, the
assigned name, Ethernet address, the authorization code (if loaded),
timeouts, number of fonts, and total memory
Color settings such as Photofine enabled and Vivid Color
Serial port settings (if installed)
Parallel port settings
LocalTalk port settings (if installed)
EtherTalk settings (if installed)
TCP/IP settings (if installed)
Novell NetWare settings (if installed)
Installing the Printer and Drivers
Saved Default
in
NVRAM
yes Phaser 340 or
Phaser 340 Plus
yes <printer name>
the default is the
same name of the
product
yes 0
no not applicable
yes not applicable
Limits or alternate choices
Any name defined by the user
up to 31 characters in length.

Service Manual

2
2-15