Resetting Nvram; Viewing Nvram Contents - Tektronix Phaser 600 Service Manual

9
Checks and Adjustments

Resetting NVRAM

Viewing NVRAM contents

9-34 Phaser 600 Color Printer
Resetting NVRAM returns all the image processor's NVRAM-stored parameters
to their factory defaults except the print count (for images processed through the
image processor) and the Adobe firmware serial number. If you do not wish to
reset the NVRAM-stored parameters of an installed PhaserShare card, then
remove the card before performing this procedure.
To reset the printer to its factory-default values, follow this procedure:
1. With the printer in its Ready state, press Menu.
2.
Scroll to the Service Support menu item.
3. Press Menu and Exit to enter the special service menu.
4. Scroll to the menu item Reset NVRAM.
5.
Press OK to reset NVRAM.
Alternately, you can also use the PC diagnostics to selectively return either the
print engine NVRAM contents to their factory default values.
You can use the PC diagnostic's NVRAM Test menu to select a test item that lets
you view and change the contents of NVRAM.
Figure 9-20 Viewing NVRAM contents