Connecting The Optional Copystation To The Printer; Figure 2-4 Connecting A Copystation To A Phaser 340 - Tektronix Phaser 340 Service Manual

Connecting the optional CopyStation to the printer

Perform this procedure if the customer has purchased a CopyStation.
Otherwise, continue to the next procedure, "Turning on the printer". The
CopyStation may be "daisychained" with one or more SCSI drives being used
for font storage. Be sure that each SCSI device uses a unique SCSI address
(0 through 4). Installing a CopyStation is fully explained in the Phaser
CopyStation User Manual.
1. Make sure that the printer and any attached SCSI disk drive are
turned off.
2.
Attach the CopyStation's SCSI cable to the printer's SCSI port. The
SCSI drive may require the SCSI cable (part numbered 013-1465-00) to
connect the drive's standard 50-pin SCSI connector to the smaller,
high-density SCSI connector on the printer's rear panel.
3. Attach the other end of the SCSI cable to the CopyStation's SCSI port.
Phaser 340 SCSI
Ethernet® PHASER 340
Service
Only
Smart Card

Figure 2-4 Connecting a CopyStation to a Phaser 340

Note The CopyStation uses two SCSI address; they are preset to 5 and 6.
Make sure that any connected SCSI hard drive does not use these
addresses.
4.
Turn on the CopyStation (and any hard drives) first, and then turn on
the printer.
5. Refer to the Phaser CopyStation User Manual for details.
Installing the Printer and Drivers
1 2
Service Reset Second
Feeder
SCSI Disk
Parallel
CopyStation
9100-11
Service Manual
2
2-13