Bypass Mode (Version 2 Printers); Figure 9-4 Main Menu Roadmap (Printers Serial-Numbered Bcxxxxx And Up - Continued) - Tektronix Phaser 340 Service Manual

Printer defaults
Default tray
Default tray: upper
Default tray: lower
Default tray: auto
Startup page
Startup page: enabled
Startup page: disabled
Startup mode
Startup mode: enabled
Startup mode: disabled
Cleaning page source
Cleaning page source: upper
Cleaning page source: lowerl
Energy Star timeout
Timeout: XXX hrs.

Figure 9-4 Main menu roadmap (printers serial-numbered BCxxxxx and up - continued)

Bypass mode (Version 2 printers)

Option P3 installed Option P2 or P4 installed
Serial settings Network settings
Data rate
TCP/IP
TCP/IP: enabled
Data rate: XXXXX
Data bits TCP/IP: disabled
EtherTalk
Data bit: 7
EtherTalk: enabled
Data bit: 8
EtherTalk: disabled
Stop bits
Stop bits: 1 NetWare
Stop bits: 2 NetWare: enabled
NetWare: disabled
Parity
HTTP
Parity: even
Parity: odd
HTTP: enabled
Parity: mark HTTP: disabled
Parity: space
Parity: none
Flow control
Flow control: XON/XOFF
Flow control: DTR
*
LocalTalk
LocalTalk: enabled
**
LocalTalk: disabled
***
****
Bypass mode allows you to access the front panel menus (bypassing the engine
and PostScript initializing processes) without having to wait for the printhead to
warm up. This way, you can reset NVRAM or read fault codes immediately.
Meanwhile, the printer continues to warm-up and initialize "in the
background."
1. Press and hold front panel buttons 1 and 2. Turn on the printer.
2. Wait for the message Entering Bypass Mode to be displayed.
Service support
"menu & exit"
"menu"
Cooldown for Power Off
Head serial number
#: XXXXXXXX
Calibration date
Calibrated: XXXX
Engine FW version
FW version: XX.XX
****
Fault history
Fault history 1
Fault history 5
Purge Volume
Standard
Low
High
Only appears when
option P3 Serial/LocalTalk
cord installed
Caution: You should never
have to change this value
Network card
Fault history 5 is the most
recent error.
Checks and Adjustments
Language
Language: English
Engine copy count
Language: Español
Test prints
Language: Français
Service print 1
Language: Deutsch
Language: Italiano
Service print 8
Language: Japanese
Head-To Drum Adjust
Reset printer
Reset NVRAM
Head adjust **
Head adjust: XXX
Authorization code ***
Field 1: XX
Field 14: XX
Network settings ***
TCP/IP address
Field 1: XXXX
Field 4: XXXX
Network mask
Field 1: XXXX
Field 4: XXXX
Broadcast mask
Field 1: XXXX
Field 4: XXXX
9100-120
Service Manual
9
9-5