8
Field Replaceable Unit Disassembly/Assembly
Code ROM SIMM
8-62
Phaser 340 Color Printer
1.
Power down the printer. Leave the power cord plugged in to provide
a ground path for static discharges.
2.
Loosen the two rear panel securing screws.
3.
Slide out the main board.
4.
Remove the currently installed code ROM SIMM by spreading apart
the pawls securing each end of the SIMM in its connector. Remove the
SIMM.
5.
Insert a replacement code ROM SIMM in connector P71 (a), and tilt
the SIMM down until it locks in place (b).
When properly inserted, a tab on each end of the connector slips into a
hole on each end of the code ROM SIMM. Also, a pawl on each end of
the connector latches around each end of the SIMM to lock it in place.
Code ROM SIMM
a
Figure 8-38 Installing the code ROM SIMM on the main board
6.
Reinstall the card cage top and the rear cabinet panels.
7.
Reconnect the host interface cables. Turn on the printer and make a
test print.
b
Main board
9100-79