Figure 8-23 Removing The Printhead - Tektronix Phaser 340 Service Manual

From
printhead
Removal tool leg
(in up position)

Figure 8-23 Removing the printhead

8. Rotate the removal tool's plastic leg into its up position. Slide the
removal tool's standoff locks inward.
9. Carefully, lower the printhead removal tool onto the printhead.
Rotate the process motor to tilt the printhead forward about 2.5 cm
(1 inch).
10. Slide the standoff locks outward to secure the tool to the printhead.
Loosen the two mounting screws securing the printhead in place.
11. Lift and remove the printhead. Lower the removal tool leg to safely
rest the printhead on a flat surface.
Ground
Field Replaceable Unit Disassembly/Assembly
Install
removal
tool
Slide lock
to secure
to printhead
Loosen
mounting
screws
9100-52
Service Manual 8-39
8